Home » News » What Are The Replacement Steps For The Cutting Pieces?
What Are The Replacement Steps For The Cutting Pieces?
With the development of the abrasives industry, there are more and more industries using cutting sheets. Among the many types of cutting sheets, green cutting disc are popular among many users and are widely used by users. Some users who have used the cutting piece know that the cutting piece needs to be replaced in order to keep the working efficiency of the cutting piece after the cutting piece has been used for a while, but some users are not familiar with these replacement steps. Today, the aurora abrasive grinding machine summarize how to replace the cutting piece?
When there is a gap in the cutting piece, the deformation or crack must be replaced. Turn off the main power supply or remove the plug to make sure it is safe.
Next, find the position of the running shaft of the cutting piece. One end of the shaft is a cutting piece, and the other end is a pulley. In the middle is the bearing housing.
There is a cylinder protruding in the middle of the bearing box on the surface of the box. This is the shaft locking device. Its principle is to press the cylinder, the other hand rotates the shaft, and the direction of rotation does not matter, it is better to swing the shaft greatly by hand. After the cylinder that is pressed at the same time encounters the small hole in the shaft, the cylindrical pin enters the hole. The shaft cannot be rotated.
At this time, hold down the cylinder and use the adjustable wrench to loosen and remove the fastening bolt. Remove the protective disc and paper pad, and the damaged cutting piece. Do not remove a piece of protective disc inside, put the new cutting piece in, and then install the paper pad and the protective disc in turn.
Tighten the bolts.
Even if the cutting piece is replaced, but if it is changed, it must be paid attention to when using it again. Learn more about the basic knowledge of using the cutting piece. Only the cutting piece has some understanding to operate and other applications. It is strictly forbidden to operate blindly and cause loss.
The above is some of the steps in the replacement of the cutting piece, I hope to be able to help everyone, can better replace the cutting piece.