Home » News » Introduction To Cut Off Wheel Dressing
Introduction To Cut Off Wheel Dressing
Henan Aurora abrasive Tool Co., Ltd is capable for all sizes cutting and grinding disc from 4″ (100mm) to 16″ (400mm). Followings are tips for the cut off wheel dressing.
The obvious sign of cut off wheel blunt is that the grinding efficiency is significantly reduced, the grinding heat is significantly increased, vibration and noise are generated, and the grinding finish is obviously reduced. At this time, the cut off disc for stainless steel be rested.
1. Remove the blunt sand from the surface of the grinding wheel, or remove the surface layer of the cut off wheel that is blocked by the grinding debris, so that the cut off wheel exposes a new surface layer to keep the cutoff wheel sharp.
2. Due to the unevenness of the abrasive grains on the surface of the cut off wheel, the shape of the cut off wheel is distorted, and the dressing can restore the accurate shape of the cut off wheel.
3. The careful dressing of the grinding wheel can significantly improve the grinding finish.
Henan Aurora Abrasive Tool Co.,Ltd.
No.55, Lotus Street, High Tech Zone, Zhengzhou city,
Henan Province, China