How To Replace The Cutting Disc?


2019-02-27-17:48:15

Users who have used the cutting disc know that the cutting disc will appear sluggish after being used for a period of time. In order to improve the efficiency of the cutting disc, many users will replace the cutting disc. But for some novice users, the initial replacement of the cutting disc may have some trouble or it will not be replaced, so how to replace the cutting disc? Today, Henan Aurora Abrasive Tool Co., LTD uses a free sample cutting disc as an example to tell you about it.

First of all, when the cutting disc of the cutting machine has a gap, the deformation or crack must be replaced, and then the main power supply is turned off or the plug is removed, so that it is foolproof.

Then find the position of the cutting axis of the cutting blade of the cutting machine. One end of the shaft is a cutting disc, the other end is a pulley, and the middle is the bearing housing. In the middle of the bearing housing, there is a cylinder protruding from the surface of the box, this is the shaft locking device. Its principle is to press the cylinder, the other hand rotates the shaft, the direction of rotation does not matter, the best way is to swing the shaft greatly by hand left and right, while the pressed cylinder encounters the small hole on the shaft, the cylindrical pin enters the hole, the shaft I can’t turn it.

At this time, press and hold the cylinder, and the other hand uses the adjustable wrench to loosen and remove the fastening bolts of the cutting disc, and then remove the cutting disc protection disc and the paper pad, in turn, the damaged cutting disc, and the inside of the protective disc is not needed. Remove, put the new cutting disc, then install the paper pad and the protective disk in turn, and finally tighten the bolt.