As the use of cutting discs is becoming wider and wider, more and more users are now using the cutting disc for cutting work, but at the same time, some users also report that the cutting disc is no longer used after a period of use. How to place it? Today, Henan Aurora Abrasive Tool Co., LTD uses the T41 green cutting disc size as an example to tell you how to repair the cutting disc.
1. When the slice is no longer sharp and the cut surface is rough, it must be repaired in time. Grinding does not change the original angle and destroys the dynamic balance.
2. If the slice is not used immediately, it should be laid flat or suspended by the inner hole. The flat cutting disc should not be stacked with other objects or feet and should be protected against moisture and rust.
3. The inner diameter correction of the cutting disc, the positioning hole processing, etc. must be performed by the factory. If the processing is poor, it will affect the product use effect and may be dangerous. In principle, the reaming should not exceed the original aperture of 20mm, so as not to affect the balance of stress.
These are some of the more common methods of maintaining cutting disc, I hope that they will be helpful to everyone. Only after understanding these methods can they be better maintained and used for a longer period of time.
Henan Aurora Abrasive Tool Co.,Ltd.
No.55, Lotus Street, High Tech Zone, Zhengzhou city,
Henan Province, China